Global Fire Equipment OCTO+ fault records

Displayed when the battery connection is broken (the manual's own test procedure is to temporarily remove the link wire between the batteries). After a short delay the SUPPLY FAULT LED comes on, the panel buzzer sounds, and the "Battery Fault" message appears on the LCD. Cleared by reconnecting the battery link and pressing SYSTEM RESET. Wording is identical to the G-One manual — both panels share the same Chameleon platform firmware.

Shown on a remote Chameleon Display (not the main panel itself) when, after initialization, serial communication between the panel and the display has not been established. The FAULT LED on the display is also lit. Wording is identical to the G-One manual.

Given in the source only as an illustrative example ("Example: 'No nodes detected'") of the network status/error text shown by programming function 8-5-3 "Installation Status", which reports the status of the network. No further cause or remedy detail is given — this is presented as an example message, not a formally enumerated fault, and is recorded as such.

Panel configuration mismatch

The OCTO+ has detected that Chameleon network panels do not hold the same system configuration or operating mode.

Displayed when the mains AC supply to the panel fails or is switched off. After a short delay the amber SUPPLY FAULT LED comes on and the fault buzzer sounds. Cleared when mains is restored and SYSTEM RESET is pressed. Wording is identical to the G-One manual.