Kentec Electronics Kentec Syncro AS fault records

Auxiliary 24 V output fuse failed

The panel has detected operation of the monitored self-resetting 500 mA auxiliary 24 V output protection.

Bad data fault

The panel has received invalid loop data from one device on four consecutive polls.

Standby battery disconnected

The panel power-supply monitoring cannot detect the connected standby battery set.

Standby battery low voltage

The monitored standby battery voltage has fallen to the panel low-voltage threshold.

The panel has detected leakage to earth; the manual specifies indication below 30 kOhm from +28 V or 0 V to earth.

Mains supply failed

The panel power-supply monitoring has detected loss of the mains supply.

Sounder/Bell Circuit Fault

A monitored sounder or bell circuit has reported an open or short circuit. The circuit is monitored at rest to ensure sounders will function when called on.

Unexpected network card

The panel has detected a newly installed network card not yet stored in its configuration.

Zone Open / Short Circuit

A conventional zone circuit has reported an open or short circuit fault. Kentec Syncro AS monitors zone wiring with end-of-line resistors (EOLR).