Fault codes by panel
Search fault records across 49 panels. Each record is labelled with its review status and, where one is cited, the source document and page it comes from.
Searches 608 records across 49 panels — 573 of them source-verified. Signed in, your dashboard fault search covers only the fully source-verified records, on any plan.
Want to test yourself? Try the free daily fault challenge.
6 partial matches for “C-TEC software and firmware”
Nothing matched every word, so these match some of them. Check the record and panel before relying on it.
Protec 6500
Network - Duplicate Master
Two master panels have been detected on the network — either two panels were assigned as master in their configuration data (correct via the PC commissioning software), or a double break in the network wiring left two…
View on the Protec 6500 pageProtec 6100
System Faults
The manual says the 6100 performs regular self tests to ensure the software is working correctly. If a fault is detected in software operation a System Fault is declared. It is a latching fault and can only be cleared…
View on the Protec 6100 pageProtec 6500
Loop Drive Series Fault
There is a high resistance in the loop wiring. The fault threshold is 80Ω (Issue E) or 50Ω (Issue F), though the manual adds that "any value greater than 32 is considered high" (no unit given). The loop current…
View on the Protec 6500 pageProtec 6500
Network - Duplicate Panel(s)
The network has initialised with two panels sharing the same number; correct this using the PC commissioning software. Neither panel is allowed to transmit an event, so each will eventually also display a Slave CTS…
View on the Protec 6500 pageNotifier by Honeywell ID50 / ID60
CONFIGURATION CHECKSUM FAILURE
Message shown on the ID50/ID60 panel. The manual's Appendix 3 gives the meaning as: Some form of corruption has been detected within the configuration settings. This can occur following a software upgrade if the memory…
View on the Notifier by Honeywell ID50 / ID60 pageEMS Fire FireCell
Checksum Error
In the Hub/RCC Fault Status menu, this message is displayed if an error is detected in either the software program or the configuration data. The manual separately notes the Radio Hub's front-plate yellow System Fault…
View on the EMS Fire FireCell page