Fault records by panel

The FlexES Control local essernet receive buffer has reached 100 percent because one or more network participants have not acknowledged telegrams despite retries. FAQ 1001 treats codes 98 and 99 as one combined…

These faults indicate the occurrence of one or more of: a. Faulty or disconnected batteries (if discharged batteries are connected, they may remain in Battery Low Voltage for a period until the voltage is raised by the…

These faults indicate the occurrence of one or more of: a. Faulty or disconnected batteries (if discharged batteries are connected, they may remain in Battery Low Voltage for a period until the voltage is raised by the…

An attempt has been made to remove one of these items while the panel is powered up. Remove power before proceeding.

These faults indicate the occurrence of one or more of: a. Faulty or disconnected batteries (if discharged batteries are connected, they may remain in Battery Low Voltage for a period until the voltage is raised by the…

Circuit broken at input 'Alarm Confirmation'.

Short circuit detected at input 'Alarm Confirmation'.

High value (Ri>0.3Ω) of the battery internal resistance. Replace the battery immediately.

The accumulator battery is missing.

The accumulator battery is discharged.

Fault in the detector.

The charging unit is failed.

Dirty detector chamber.

More than one device with the same address in the loop.

Doubling of the panel number, when two or more panels are connected in a network.

Resistive connection between some signals and earth, below 10kΩ.

Event message on the SIMPO addressable panel. The manual's Appendix A table describes it as: Circuit broken at Extinguishing output. The manual gives no cause or action for this message.

Short circuit detected at Extinguishing output.

Event message on the SIMPO addressable panel. The manual's Appendix A table describes it as: Circuit broken at Fault output. The manual gives no cause or action for this message.

Short circuit detected at Fault output.

As given in the source's own event table: "Short circuit (the mains power supply is lost)" — the source's wording for this entry is terse and possibly abbreviated; quoted as written rather than expanded.

Circuit broken at input 'Protection Panel Fault'.

Short circuit detected at input 'Protection Panel Fault'.

Event message on the SIMPO addressable panel. The manual's Appendix A table describes it as: Circuit broken at Fire output. The manual gives no cause or action for this message.

Short circuit detected at Fire output.

FLASH Memory error is detected.

Lights on permanently in case of a fault event in the system.

The log file event is lost or damaged.

The loop is broken.

The device does not respond (lost or damaged).