Panel fault records

Fault records by panel

Fault records for a small, deliberately staged set of panels. Each record is labelled with its review status and, where one is cited, the source document and page it comes from. More panels are added as more records go through source review.

Searches 148 records across 6 panels.

4 partial matches for “FC726S / FC726S-10”

Nothing matched every word, so these match some of them. Check the record and panel before relying on it.

Notifier by Honeywell ID3000

SENSOR FAULT

Not yet verified

For VIEW, MULTI (Optiplex), or SMART sensors: the analogue reading is below the Chamber fault threshold, or below the Maintenance Urgent threshold, or a Maintenance Alert has existed for longer than 100 days without any…

View on the Notifier by Honeywell ID3000 page

Advanced MxPro 4

Sounder Load Too High

Not yet verified

From the panel's own "View - Panel" diagnostic table: Sounder A/B Load is monitored 0mA-1000mA; the panel reports Too High when the loop current exceeds the expected range.

View on the Advanced MxPro 4 page

Advanced MxPro 5

DEVICE CONTAMINATION

Not yet verified

Raised against an analogue loop device once its measured compensation-drift value exceeds a preset limit — typically dust or contamination affecting a detector's chamber over time. Preceded by a non-fault "Warning"…

View on the Advanced MxPro 5 page

Protec 6500