Fault records by panel

In the Hub/RCC Fault Status menu, this indicates a remote aerial on the RCC or Radio Hub is not attached or is damaged (monitoring resistance of 47 kΩ not present). The manual separately notes the Radio Hub's…

The PSU's Battery Fail LED illuminates when the battery is disconnected.

In the device Fault Status menu, this shows the device has either a low battery (minimum operational life 7-30 days remaining) or a battery missing.

In the Hub/RCC Fault Status menu, this indicates either no battery present, a low battery, or a battery charger failure on an RCC.

The PSU's Battery Low LED illuminates when the battery voltage is below 5.7 V.

In the Hub/RCC Fault Status menu, this message is displayed if an error is detected in either the software program or the configuration data. The manual separately notes the Radio Hub's front-plate yellow System Fault…

In the Hub/RCC Fault Status menu, this indicates radio-frequency interference has been detected on radio channel 1 of the radio device-to-RCC communication path.

In the Hub/RCC Fault Status menu, this indicates radio-frequency interference has been detected on radio channel 2 of the radio device-to-RCC communication path.

In the device Fault Status menu, this shows the detector's head is deemed dirty or contaminated.

In the device Fault Status menu, this indicates a detector's head has a fault, i.e. no communication between the head and the wireless base.

In the device Fault Status menu, this indicates the detector's head, sounder, strobe-only or sounder/strobe head is not currently fitted on the wireless base.

In the device Fault Status menu on the Radio Hub, this indicates the device's tamper switch is not currently making contact against the ceiling- or wall-mounted base plate.

The PSU's Mains / Charger Fail LED illuminates whilst the PSU cannot detect a valid mains supply, or when the battery is not charging.

In the Hub/RCC Fault Status menu, this indicates there is no mains present on the Radio Cluster Communicator (RCC).

In the Hub/RCC Fault Status menu, this indicates there has been no communication between the Radio Hub and an RCC for 300 seconds, or communication is being achieved but not at an acceptable level; it may also indicate…

In the device Fault Status menu: the primary and secondary stage sounder tones can be monitored; if enabled and no audio is detected within 10 seconds of sounder activation, this fault is indicated.

In the device Fault Status menu, this indicates an open-circuit wiring fault on the input of an Input/Output (I/O) unit.

In the Hub/RCC Fault Status menu, this indicates the on-board processor on an RCC or the Radio Hub is in a failure condition.

The PSU's Fault LED illuminates whilst any fault is present at the PSU.

In the Hub/RCC Fault Status menu, this indicates radio-frequency interference has been detected on radio channel 1 of the RCC network communication path.

In the Hub/RCC Fault Status menu, this indicates radio-frequency interference has been detected on radio channel 2 of the RCC network communication path.

In the Hub/RCC Fault Status menu, this indicates one of the on-board wireless receivers on an RCC or the Radio Hub is in a failure condition.

In the device Fault Status menu, this indicates a short-circuit wiring fault on the input of an Input/Output (I/O) unit.

In the device Fault Status menu, this is shown for two reasons: there has been no communication between the device and its Radio Cluster Communicator (RCC) for 300 seconds, or the signalling path is poor and…

In the device Fault Status menu, this indicates the device is not yet assigned to the system. Assign it via the rotary control or the Assign Devices menu option.