Fault records by panel

Individual zone and monitored input indicators are provided for both fire/alarm and fault conditions. A flashing zone/input Fault LED together with the general FAULT LED indicates a fault in that zone. The same…

This indicates the auxiliary supply has a fault.

This indicates there is a low voltage level on the batteries, or the battery charger circuit has failed.

When this indicator is on, there is leakage current flowing between the earth connection/wiring and any other wire connected to the panel.

This LED indicates any fault condition present on the panel. If there is a communication fault between the ORION and an ORION MINI-REP, a Sounder/Relay module or a GFE-ADLI V2 module, this LED flashes once per second.…

If there is an RM output circuit fault, the general FAULT LED is lit and the DISABLE SELECTED ZONES LED in the Disablements section flashes.

If there is a conventional sounder output circuit fault, the general FAULT LED is lit and the DISABLE SOUNDERS LED in the Disablements section flashes.

This LED is on whenever the main supply has been removed or has dropped below 20 volts.

This LED is lit whenever there is a processor failure or corruption of the panel firmware.

Displayed when the battery connection is broken (the manual's own test procedure is to temporarily remove the link wire between the batteries). After a short delay the SUPPLY FAULT LED comes on, the panel buzzer sounds,…

Reported via the normal fault mechanism (and logged) when programming function 6-3-5 "Check for Devices Needing Service" finds a ZEOS-protocol device close to its drift-compensation limit. No further cause or remedy…

Shown on a remote Chameleon Display (not the main panel itself) when, after initialization, serial communication between the panel and the display has not been established. The FAULT LED on the display is also lit. The…

The G-One has detected that Chameleon network panels do not hold the same system configuration or operating mode.

Displayed when the mains AC supply to the panel fails or is switched off. After a short delay the amber SUPPLY FAULT LED comes on and the fault buzzer sounds. Cleared when mains is restored and SYSTEM RESET is pressed.

Displayed when the battery connection is broken (the manual's own test procedure is to temporarily remove the wire linking the batteries). After a short delay the SUPPLY FAULT LED comes on, the panel buzzer sounds, and…

Shown on a remote Chameleon Display (not the main panel itself) when, after initialization, serial communication between the panel and the display has not been established. The FAULT LED on the display is also lit.…

Given in the source only as an illustrative example ("Example: 'No nodes detected'") of the network status/error text shown by programming function 8-5-3 "Installation Status", which reports the status of the network.…

The OCTO+ has detected that Chameleon network panels do not hold the same system configuration or operating mode.

Displayed when the mains AC supply to the panel fails or is switched off. After a short delay the amber SUPPLY FAULT LED comes on and the fault buzzer sounds. Cleared when mains is restored and SYSTEM RESET is pressed.