Fault codes by panel
Search fault records across 49 panels. Each record is labelled with its review status and, where one is cited, the source document and page it comes from.
Searches 608 records across 49 panels — 573 of them source-verified. Signed in, your dashboard fault search covers only the fully source-verified records, on any plan.
Want to test yourself? Try the free daily fault challenge.
6 partial matches for “Hochiki Europe manuals”
Nothing matched every word, so these match some of them. Check the record and panel before relying on it.
Hochiki HFP AP-1AS/2AS
General Fault
The yellow General Fault LED flashes when there is a fault on the system. Other fault LED indications may also be present to identify the nature of the fault. The Fault Contact energises and the panel buzzer sounds…
View on the Hochiki HFP AP-1AS/2AS pageHochiki HFP AP-1AS/2AS
Sounder Fault / Disabled
Combined fault/disablement LED for sounder outputs. Illuminates if a sounder output fault is present, and also illuminates (with the General Disablement indicator) when sounder outputs are deliberately disabled via the…
View on the Hochiki HFP AP-1AS/2AS pageHochiki HFP AP-1AS/2AS
Double address (fault announced at loop initialisation)
Per the manual, the control panel can detect devices set to the same address and will announce a “Double address” fault if it finds any. It cannot tell which devices are double addressed. To help find them, go to access…
View on the Hochiki HFP AP-1AS/2AS pageHochiki HFP AP-1AS/2AS
Fault events are non-latching (Reset does not clear them)
Per the user manual, the Reset button is used to reset any activation defined as a latching input type, which includes fire and pre-alarm events. In general, fault events are non-latching and cannot be cleared by…
View on the Hochiki HFP AP-1AS/2AS pageHochiki HFP AP-1AS/2AS
Loop open circuit or short circuit (how the panel responds)
Per the manual, power is driven from the LOOP OUT terminals and returned to the LOOP IN terminals, where it is monitored for loop continuity. If the loop is open circuit (a cable fault, or a short circuit isolator…
View on the Hochiki HFP AP-1AS/2AS pageHochiki HFP AP-1AS/2AS
System fault message after a PC configuration download
Per the manual, after a configuration is sent back to the panel from the PC (write enable on, then synchronise), the panel shows RECEIVING NEW CONFIGURATION, PLEASE WAIT during the transfer and then the start-up…
View on the Hochiki HFP AP-1AS/2AS page